on of Work Prepara -â€” Elect al (contd) c After clamping, check each harness to be certain that it is not interrarring with any movtng or sliding parts a! the vehicle. - Keep wire harnesses away from the exhaust pipes and other hot parts. - Always keep a saie distance between wire har- nesses and any healed parts. Keep suuiciem distancti - Do not bring wire harnesses in direct contact with sharp edges or earners. Also avnid Contact with the proiscied ends a! bolts, screws and other insteners. - Route harnesses so they are not pulled taut or slackened excessively, Protect wires and harnesses with a rape or tube if they are in contact wirh a sharp edge or earner, Clean the attaching surrace thoroughly ir a plaster is used. Use a spirit wipe if necessary. O x Seat grommets in their grooves properly. Do not damage [he insulator when connecting a wire. Do not use wires or harnesses with a broken insular tar. Repair by wrapping with a protective tape or replace with new ones if necessary. 0 X After installing parts, make sure that wire harness- es are not pinched.