Summary of Contents for Honda Accord 1990-1993 Service Manual - Page 16

  • Honda Accord 1990-1993 Service Manual - Page 16

    . Be sure to replace washers, Oarlngs, and rubber seals with new Dnfi when servicing fuel line parts. Always apva oil to the surlaces ol O-rings and seal rings before installation Never use brake fluid, radiator lluid, vegetable oils or alcohol- oased oils. nuaeen SEAL ®3 o-nmc E ’ CUSHION runs 4. FUEL INJECTOR - When assembling the «are i t or the high- pressure iuel line. clean the joint and coat with new engine oil. ‘ When Installing an Injector, check the angle at the coupler. The center line of the coupler should align with the setting mark on the injector holder. ,J ’@ ’_—‘ SETYING MARKS inspection for ruel leakage Alter assembling fuel line parts, turn ON the ig~ nition switch [do not operate the starter) so that the fuel pump is operated for approximately two seconds and the fuel is pressurized. Repeat this operation two or three times and check whether any fuel leakage has occurred in any ot the vari- ous points rn the fuel line. lnstallation or an amateur radio tor cars equipped with PGMVFI. Care has been taken her the Fuel-Injection, Car- buretor, A/T, Cruise control and ALB control unlls and its wiring to prevent erroneous operatron irorn external interference, but erroneous operatrun at the control units may be caused by entry of extremely strong radio waves Attention must he paid to the following items to prevent erroneous operation or the control unr s. - The antenna and the body of the radio must be at least 200 mm (73 in.) away from the control units. The control unit locations: ~ Fuel-Injection. Carburetor, A/T: Passengers stde from floor panel, - Cruise control. Under dash panel 0 drivers side. - ALB: Right side panel of trunk morn. Do not lead the antenna leeder end the coaxial cable over i long distance parallel to the cars wiring. When crassmg the wiring is required, execute crossing at a right angle. Do not Install a radio wlth a large output (max. ‘0 W). Apply quurd gasket to the transmission. oil pump cover, right side cover and water outlet. Use HONDA genuine Li uid gasket part No. 0Y740 —99986 0 Check that the mating surfaces are clean and dry belpre applying liquid gasket Dagrease the mating surfaces il necessary. ‘ Apply liquid gasket evenly, being caralul to cover all the mating surface. « To prevent leakage ol oil, apply liquid gasket lo the inner threads DI the bolt holes. - Do not install the parts it 20 minutes or more have elapsed since applying liquid gasket, In that case, reapply liquid gasket after removing the old residue. v Walt at least 30 minutes betore filllng with appropri- ate llquld (engine Oil, coolant and similar (Inlds). 1-13