Summary of Contents for Honda Accord 1993-62SN700 Service Manual - Page 48

  • Honda Accord 1993-62SN700 Service Manual - Page 48

    Engine Removal/Installation - (contdl 49. Install the engine in the reverse order of removal. NOTE: Allen the engine is in place: 0 Torque the engine mounl bolts/nuts in the see quanoe shown below, CAUTION: Falluve tn tighten the bolls/mus in tha proper sequance can cause exoexsive also and viblallon, and reduce bushing Illo; chock that the bushings are not twisted or one. 10 x 1.25 mm 4 33 Man TRANSMISSION Mount ‘33 ham, 23 Ibrm @ Tighten snug only. 12 x v.25 mm (is) 35 N-m (6.5 kg-m. 47 lb-fll 12 x 1.25 mm 65 Nm (6.5 Its-m. 47 lb-h) Raplace. FRONT MOUNT 12 x 1.25 mm @ s5 N-m (6.5 kg-m. 47 lb) Replace. 0 Check «lat xhe spying clip on me and a! each driveshaft clicks in (0 place. CAUTION: Install new spring clips. 0 Blend all from the coollng system It (ll. bleed bolt wlth the heater valve open. Q Adjust the (home cable tension. Check the clutch pedal froeplely (MIT). I check that the trunsmlsslon shi smoothly. REAR MOUNT 12 x 1.25 mm ® 55 Man SIDE ENGIN (5.5 kg~m, moum / 40 Ib-fl) G) Tlgmen snug only. I2 x 1.25 mm (5) 35 N-m (3.5 mm. NOTE: Torque the moumlng bolls/nuts me 47 Ib-m numbered sequence as shown (@7). 5-12