Summary of Contents for Honda Accord 1994 CE1 CE2 Service Manual - Page 45

  • Honda Accord 1994 CE1 CE2 Service Manual - Page 45

    Road Test NOTE: Warm up the engine to normal operating temperature (the radiami fan comes on). it Apply parking brake and block the wheels, Stan the engine, then mave the selemor lever ta position while depressing the brake pedal. Depress the accelerator pedal and release it suddenly. The engine should not stall. 2. Repeat same tesl in position, 3. shift the selector lever to position, and check that the shift poinls occur at approximate speeds shown. Also check ior abnormal noise and clutch slippage. NOTE: Throttle position Sensor Vol‘age represents the throttle opening 71. Connect the Test Harness between the ECM and connector (see section 11). 72‘ Set the digital multimeter to check voltage between D11 (H terminal and D22 (—l terminal for the throttle position sensor. CAUTION: o All sns elmncal ng harnesses are covered with ycllow ineul n. a Before disconnecting any part or the sns wire harness, connect the short connectors. 0 Replace the entire affected sns harness assem- bly if it ha: an open circuit or damaged wiring. NOTE: The illustration shows LHD lype. RHD type is symmetrical to LHD type, sns MAIN HARNESS NOTE: LHD is shown: RHD is similar. 1:51 HARNESS 07w - mfl‘luA or 01W - PT30|00 DIGrrAL MULflTESTEH Commercially available or 07411 ~ ooznooo on M oooooouoooooo cocooooo ooooao 00000000000 ooooooooooooo ooooooeo ooooeo ooooeueoooe D22 l-l 1 4-2