Summary of Contents for Honda Accord 1996 62SN725 Service Manual - Page 11

  • Honda Accord 1996 62SN725 Service Manual - Page 11

    . WHT/Y EL fi LAMP (MIL) Troubleshooting — Self—diagnostic Procedures IV when the Mallunction indicator Lamp (MIL) has been reported on. do the loliowing: 3) Procedure with PGM—Tester: Connect the FEM—Tester with the 5P Data Link Connector (DLC) located under the clash on the driver‘s side oi the car. The PGM—Tester will display the trouble code. [7) Procedure without PGM—Tesler. Connect the Data Link Connector terminal 3 (L—Line) to terminal 1 (GND) with a jumper wire as shown or with ABS short—Connector (the Data Link Connector (SP) is located under the dash on the driver‘s side oi the car) Turn the ignition switch on (L—Une) WHT/FNK WARNING: (K— Line] DO NOT CONNECT FIN 2 T0 GROUND BECAUSE THIS PIN IS BATTERY +, Data Link Connector (5p) jumper wue Ii. Note the Diagnostic Trouble Code (DTC): the MIL indicales a laiiure code by a number of blinks until the jumper wire is removed from the DLC (5P), Each blink code is indicated three times in succession. beginning with blink code 12 (initialisation code—0K). MALFUNCTION INDICATOR I. er blink code 14 f M more 11-12