Summary of Contents for Honda Accord 1986 SE 300 Service Manual - Page 11

  • Honda Accord 1986 SE 300 Service Manual - Page 11

    Preparation of Work — Special Caution Items For This Car (contd) 4. lnspeciion tor luel leakage - After assembling vuel line parts, turn ON the igr nition switch (do not operate the starter) so that the luel pump is operated for approximately two seconds and the fuel is pressurized. Repeat this operation two or three times and check whether any fuel leakage has occurred in any or the vari- ous points in the fuel line. 5. Installation of an amateur radio for cars equipped with PGM»FI and A.L.B. Care has been taken for the PGM-Fl and A.L.E. con- trol units (computer) and its wiring to prevent erroneous operation lrom external intertarence, but erroneous operation of the computer may be caused by entry or extremely strong radio waves. Attention must be paid to the tollowing items to prevent erroneous operation or the computer. - The antenna and the body of the radio must be at least 200 mm (7.9 in.) away from the computer. (The computer installation position is under the right side seat.) - Do not lead the antenna feeder and the co al cable over a long stance parallel to the wiring, and when crossing With the wiring is required, execute crossing at a right angle. o Do not install a radio With a large output (max. 10 W]. 6. Apply liquid gasket to the transmission, oil pump cover, right aide cover and water outlet, Use HONDA PAHTS NO 08740— 95986 as a liquid gash kett - Check that the mating surlaces are clean and dry oelore applying liquid gasket. Degrease the mating surtaces if necessary. - Apply liquid gasket evenly, being careful to cover all the mating surface. » To prevent leakage of oil, apply liouid gasket to the inner threads of the bolt holes. i no not allow liquid gasket to stand tor more than 20 minutes belnle assembly, - Fill the case with clean engine oil or coolant 30 minutes after assembly. CAUTION: Observe all satoty precautions and notes while working. Protect all painted surfaces and seats against dirt and scratches With a clean cloth or vinyl cover. Work sarely and give your work your undivided at tention. When either the lront or rear wheels are to be raised, block the remaining wheels securely. Exchange signals as frequently as possible when a work Involves two or more workers. Do not run the engine unless the shop or working area is well ven- tilated. Prior to removing or disassembling pans, they must he inspected caietully to isolate the cause for which the service is called for. Observe all salety notes and precautions and follow the proper proce dures as described in this manual. .1/ / fiq / Mark or place all removed parts in order in a parts rack so they can be placed back to their original places or parts lrorn which they were removed or with which they were mated. 2v 1-10