Remove the handle sleeve (Item 1) and bushings (Item 2) [Figure 50-111-12] from the handle. Check all parts for wear and replace as needed. Check…
Author: Jack
To remove the handle control unit, slide the rubber handle cover (Item 1) [Figure 50-111-3] up the handle. Remove the two mounting bolts (Item 2)…
Control Handle (Item 1) [Figure 50-111-1]. Handle Control Unit (Item 1) [Figure 50-111-2].
The following tool listed will be needed to do the following procedure: MEL1563 – Remote Start Tool Kit Connect the remote start tool to the…
Push the control lever to full stroke and turn drift adjustment bolt (Item 1) [Figure 50-110-24] in until it touches the U-bolt holding the control…
Remove access plug from the top of the control panel. Turn the control lever drift adjustment bolts (Item 1) [Figure 50-110-17] (one on each control…
Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Lift and block the…
Remove the nut (Item 1) from the end of the centering spring shoulder bolt (Item 2) [Figure 50-110-7]. Remove the shoulder bolt/spring assembly. Installation: Tighten…
To replace the rubber boot (Item 1) [Figure 50-110-6] on the control panel, remove the control lever (See Lever Removal And Installation on Page 50-110-2.)…
Disconnect the electrical connectors from the control lever [Figure 50-110-5]. Remove the nuts from the two U-bolts (Item 1) [Figure 50-110-5] used to mount the…