Remove the nut (Item 1) [Figure 50-31-6] from the seat belt mount. Remove the seat belt. Installation: Tighten the mounting nuts to 58 – 62…
Author: Jack
Raise the operator cab. (See Raising on Page 10-30-2.) Remove the operator seat. (See Removal And Installation on Page 50-31-1.) Remove the two slide rail…
Raise the operator cab. (See Raising on Page 10-30-2.) Remove the four seat mounting nuts (Item 1) [Figure 50-31-1] and washers from the operator seat…
Raise the operator cab. (See Raising on Page 10-30-2.) Locate the seat belt bolts under seat pan insulation (Items 1 & 2) [Figure 50-30-3] and…
Remove the operator cab gas cylinder(s). (See Gas Cylinder Removal And Installation on Page 50-20-1.) Remove the heater unit from the cab (if equipped). (See…
Remove the clevis (Item 1) and washer (Item 2) [Figure 50-20-9] from the end of the gas cylinder. Remove the gas cylinder from the outer…
Remove the operator cab stop (Item 1) (both sides) [Figure 50-20-1]. Remove the cab nut and holddown plate (Item 1) [Figure 50-20-2] (both sides). Installation:…
Turn the bolt (Item 1) [Figure 50-10-12] & [Figure 50-10-11] out of the clevis. Assembly: Apply Loctiteยฎ #518 adhesive to the bolt threads. Adjust the…
Assemble the parts as shown for the left side of the seat bar pivot assembly [Figure 50-10-7] & [Figure 50-10-8]. Seat Bar Mount (Item 1)…
Raise the seat bar (Item 1) [Figure 50-10-1]. Disconnect the seat bar sensor (Item 1) [Figure 50-10-2] from the cab harness. Lower the seat bar.…