The case drain filter is an external filter assembly in the case drain circuit that filters the case drain hydraulic oil. The case drain filter…
Author: Jack
Install the spring (Item 1) on the pulley (Item 2) [Figure 30-60-15] as shown. Install the shaft from the bracket assembly (Item 1) into the…
Remove the grease cover (Item 1) [Figure 30-60-11]. Remove the bolt (Item 1), the flat washer (Item 2), the retainer washer (Item 3), the spring…
Stop the engine. Open rear door. Remove the negative (-) cable from the battery. the battery may be removed for additional working clearance. (See Removal…
Stop the engine. Open the rear door. Raise the operator cab. (See Raising on Page 10-30-2.) Remove the negative (-) cable from the battery. The…
To adjust the drive belt between the flywheel and the hydrostatic pump pulley, use the following procedure: Stop the engine. Open the rear door. Disconnect…
Remove the three drive belt shield mounting clips (Item 1) [Figure 30-60-1]. Remove the belt shield (Item 1) [Figure 30-60-2]
The drive belt makes the mechanical connection from the engine flywheel to the hydrostatic pump pulley. The belt is a cord-reinforced rubber design. Constant tension…
The hydraulic controller neutral adjustment, aligns the pump swash plate and the control spool so that a zero angle control setting provides a zero degree…