Remove the four bolts (Item 1) [Figure 30-50-8] from the pump housing end cap. Remove the pump housing end cap (Item 1) [Figure 30-50-9]. Remove…
Author: Jack
Ensure the hydrostatic reservoir is filled to the correct level before starting the engine. (See Checking And Adding Fluid on Page 10-120-1.) NOTE: Because the…
Remove the engine/hydrostatic pump assembly from the loader. (See Engine Removal And Installation on Page 70-10-8.) Remove the control handle linkage from the hydrostatic pump.…
There are four replenishing/high pressure relief valves (Item 1) [Figure 30-50-1] in the hydrostatic pump assembly. Two are located at the top of the pumps…
The hydrostatic pump is composed of two hydrostatic piston pumps connected together. The pumps provide bidirectional flow to two separate hydrostatic drive motors. The pump…
If the charge pressure is not correct loosen the charge relief valve plug (Item 1) [Figure 30-40-6]. Assembly: Always use a new O-ring. Tighten the…
Disconnect the charge pressure sender connector (Item 1) [Figure 30-40-5] from the sender. Remove the sender (Item 2) [Figure 30-40-5] from the adapter fitting. Installation:…
The tools needed to check charge pressure, hydraulic hose (Item 1), Hydraulic gauge (1000 PSI) (Item 2) and adapter fitting (P/N 93F-5) (Item 3) [Figure…