The following troubleshooting chart is provided for assistance in locating and correcting problems which are most common. Many of the recommended procedures must be done…
Author: Jack
Remove the floor mat and floor panel. (See Removal And Installation on Page 40-110-1.) Remove the three screws (Item 1) [Figure 40-230-1]. Remove the screws…
Loosen the two nuts and two bolts (Item 1) [Figure 40-220-6] and adjust the latch. Loosen the two nuts (Item 1) [Figure 40-220-6] and adjust…
Remove the nut, bolt and clamp (Item 1). Remove the bolts and nuts (Item 2) and remove the latch (Item 3) [Figure 40-220-3]. Remove the…
Open the right side cover. Remove the clip (Item 1). Support the cover and separate the support (Item 2) [Figure 40-220-1]. Support the cover and…
Install bushing (Item 1), O-ring (Item 2) and bushing (Item 3) [Figure 40-211-24] in both locking pin bores. Install reversing lever (Item 1), pin (Item…
Remove the eight bolts (Item 1) and cover (Item 2) [Figure 40-211-10]. Remove all sealant (Item 1) [Figure 40-211-11] from the housing and cover. NOTE:…
Remove the two bolts (Item 1) [Figure 40-211-8] and lock washers. Turn the threaded spindle (Item 1) counterclockwise until the locking mechanism (Item 2) [Figure…