Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.) Raise the operator cab. (See Raising on Page…
Author: Jack
Raise the lift arms and install an approved lift arm device. (See Installing on Page 10-20-1.) Raise the operator cab. (See Raising on Page 10-30-2.)…
The tools listed will be needed to do the following procedure: MEL10630 – Engine Compression Kit MEL1631 – Compression Adapter The engine must be at…
Use the following procedure to install new engine mounts: Remove the existing mount from the engine. Refer to engine removal and installation for engine mount…
Put jackstands under the rear corners of the loader. Raise the lift arms and install an approved lift arm support device. (See Installing on Page…
The following troubleshooting chart is provided for assistance in locating and correcting problems which are most common. Many of the recommended procedures must be done…
All dimensions are given in inches. Respective metric dimensions are given in millimeters enclosed by parentheses.
All dimensions are given in inches. Respective metric dimensions are given in millimeters enclosed by parentheses. All dimensions are given in inches. Respective metric dimensions…
The S130 has a Kubota direct injected V2203-M-DI diesel engine [Figure 70-10-1] with a displacement of 134 cu.in. (2,2 L). The engine is rated at…
NOTE: Joystick equipped machines do not have back-up alarm switches and can not be adjusted. Standard Controls and ACS (If Equipped) Stop the engine and…