To determine the correct number and thickness of the shims needed, the inside of the outer arm and the outside of the inner arm will…

Build the service tool to assist in aligning the rod end of the cylinder between the left and right rod end pin boss. Use the…

Remove the seals (Item 1) [Figure 40-161-8] from both sides of the arm. Remove the bushings (Item 2) [Figure 40-161-8] from both sides of the…

Remove the seals (Item 1) [Figure 40-161-6] from both sides of the arm. Remove the bushings (Item 2) [Figure 40-161-6] from both sides of the…

Remove the bucket or attachment. (See the Operation and Maintenance Manual for the correct procedure.) Fully retract the arm and install the pin (Item 1).…

Remove the seals (Item 1) [Figure 40-160-5] from both sides of the arm. Remove the bushings (Item 1) [Figure 40-160-6] from both sides of the…

Remove the seals (Item 1) [Figure 40-160-3] from both sides of the arm. Remove the bushings (Item 2) [Figure 40-160-3] from both sides of the…

Remove the arm cylinder. (See Removal And Installation on Page 20-22-3.) Support the arm with a chain hoist (Item 1) [Figure 40-160-1]. Remove the hydraulic…

Remove the arm. (See Removal And Installation on Page 40-160-1.) Remove the boom cylinder. (See Removal And Installation on Page 20-20-3.) Disconnect the wire harness…

Apply a film of grease to the outer diameter of the bushing and to the inner diameter of the casting. Center the bushing on the…