Lift the rubber boot (Item 1) [Figure 50-112-5]. Remove the four screws (Item 1) [Figure 50-112-6] to lift the joystick control from the base. Disconnect…

The tools listed will be needed to do the following procedure: MEL1608-Joystick Test Harness [Figure 50-112-1] MEL1563 or 6689779-Remote Start Tool Multimeter Raise the lift…

To replace the rubber boot (Item 1) [Figure 50-111-22] on the control panel, remove the control lever. (See Boot Removal And Installation on Page 50-110-1.)…

Disconnect the electrical connectors (Item 1) [Figure 50-111-18] from the control lever switch handle. Remove the electrical connectors from the control lever switch handle. (See…

Remove the handle sleeve (Item 1) and bushings (Item 2) from the handle [Figure 50-111-16]. Check all parts for wear and replace as needed. Check…

Remove the handle sensor (Item 1) [Figure 50-111-12]. (See Handle Sensor Removal And Installation on Page 50-111-1.) Remove the switch handle (Item 1) [Figure 50-111-13].…

Loosen the nuts (Item 1) [Figure 50-111-2]. Installation: Tighten the u-bolts so the lever can not be moved either right or left when seated in…

The control handles/levers are used to control the forward and reverse travel and the lift and tilt functions.The lift and tilt functions can be controlled…

To replace the rubber boot (Item 1) [Figure 50-110-2] on the control panel, remove the control lever (See Lever Removal And Installation on Page 50-110-1.)…

Disconnect the electrical connectors (Item 1) [Figure 50-110-1]. Remove the nuts from the two U-bolts (Item 2) [Figure 50-110-1] used to mount the control lever.…