Raise the loader operator cab. (See Raising on Page 10-30-2.) Disconnect the harness (Item 1) and loosen the fuel level sender (Item 2) [Figure 50-80-5]…

Remove the cover (Item 1) [Figure 50-80-1] which is installed over the fuel drain near the rear of the chaincase. Installation: Tighten the cover mounting…

Disconnect the spring (Item 1) [Figure 50-70-7] from the rear door. Remove the bolt and nut (Item 2) [Figure 50-70-7] from the latch. Remove the…

Loosen the striker assembly mount bolts (Item 1) [Figure 50-70-6]. Align the striker assembly in the center of the mounting holes. NOTE: Tighten the striker…

Remove the lock nut (Item 1) [Figure 50-70-5]. Remove the rollers (Item 2) and the spacer (Item 3) from the bolt (Item 4) [Figure 50-70-5].…

Remove the two striker mount bolts (Item 1) [Figure 50-70-4]. Remove the striker assembly from the loader.

Disconnect the light harness connector (Item 1) [Figure 50-70-1] from the engine harness. Remove both rear lights (Item 2) [Figure 50-70-1] from the door. (See…

Open the rear door. Lift up on the rear grill (Item 1) [Figure 50-60-1] and [Figure 50-60-2]. Lift the grill away from the loader. Installation:…

Roll the Bob-Tach fully forward. Stop the engine. Remove the Bob-Tach frame from the lift arms. (See Removal And Installation on Page 50-40-1.) Install jackstands…

Remove the Power Bob-Tach. (See Removal And Installation on Page 50-41-1.) Remove the rubber seal (Item 1) [Figure 50-41-13]. Installation: Use a new seal when…