Clean the surface of the cylinder head. Put a straight edge (Item 1) [Figure 70-80-22] on the cylinder head. NOTE: Do not put the straight…

Use a valve spring compressor to compress the valve spring [Figure 70-80-20]. Remove the valve cap (Item 1) and valve spring collet (Item 2) [Figure…

Remove the glow plug lead (Item 1), breather hose (Item 2), and valve cover bolts (Item 3) [Figure 70-80-9]. Remove the valve cover (Item 4)…

Stop the engine and open the rear door. Remove the engine. (See Engine Removal And Installation on Page 70-10-8.) Remove the timing gearcase cover. (See…

Adjust the valve clearance as follows: Loosen the lock nut (Item 1) [Figure 70-80-5]. Turn the adjustment screw (Item 2) [Figure 70-80-5] until the correct…

Disconnect the negative (-) cable from the battery. Remove the nut (Item 1) [Figure 70-80-2] from the top of each glow plug. Disconnect the engine…

Disconnect the glow plug cables and leads. Use an ohmmeter to check the glow plugs. Touch one probe to the end of the glow plug…

The tool listed will be needed to do the following procedure: OEM1064 – Injector Nozzle Tester Set the injection nozzle to a nozzle tester. Raise…

The tool listed will be needed to do the following procedure: OEM1064 – Injector Nozzle Tester Set the injection nozzle to a nozzle tester, and…

The tool listed will be needed to do the following procedure: OEM1064 – Injector Nozzle Tester Set the injection nozzle to the nozzle tester. Slowly…