Disconnect the wire harness connector (Item 1) [Figure 70-40-1] from the air cleaner sensor on the air cleaner. Loosen the hose clamp (Item 1) [Figure…

Stop the engine and open the rear door. Remove the rear grill. (See Removal And Installation on Page 50-60-1.) Remove the exhaust pipe clamp (Item…

Remove the spring (Item 1) [Figure 70-21-10] from the foot speed control assembly. Remove the bushing/nut (Item 1) [Figure 70-21-11] from the pedal lever. Remove…

Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.) Raise the operator cab. (See Raising on Page…

Raise the lift arms and install an approved lift arm device. (See Installing on Page 10-20-1.) Raise the operator cab. (See Raising on Page 10-30-2.)…

The tools listed will be needed to do the following procedure: MEL10630 – Engine Compression Kit MEL1631 – Compression Adapter The engine must be at…

Use the following procedure to install new engine mounts: Remove the existing mount from the engine. Refer to engine removal and installation for engine mount…

Put jackstands under the rear corners of the loader. Raise the lift arms and install an approved lift arm support device. (See Installing on Page…

The following troubleshooting chart is provided for assistance in locating and correcting problems which are most common. Many of the recommended procedures must be done…

All dimensions are given in inches. Respective metric dimensions are given in millimeters enclosed by parentheses.