Standards and Service Limits

Steering

2-15  
Item Measurement Qualification Standard or New Service Limit
Steering wheel Rotational play measure at outside edge With engine running 0-10 mm (0-0.39 in.) -
Starting load measured at outside edge With engine running 29 N (3.0 kgf, 6.6 lbs) -
Gearbox Angle of rack guide screw loosened from locked position   20° Max.
Pump Output pressure with shut-off valve closed Engine speed at 3,000 rpm (min) 7,600-8,300 kPa (78-85 kgf/cm2, 1,110-1,210 psi)
290-1,100 kPa (3-11 kgf/cm2, 43-156 psi)
Power steering fluid Capacity Use Genuine Honda power steering fluid For reservoir capacity: 0.3 l (0.32 US qt, 0.26 Imp qt)
For system capacity: 1.0 l (1.06 US qt, 0.88 Imp qt)
Power steering pump belt NOTE: Adjust a new belt to the new belt spec, run the engine for 5 minutes, then readjust it to the used belt spec. Deflection with 98 N (10 kgf, 22 lbs) applied mid-way between pulleys   Used belt: 13.0-16.5 mm (0.51-0.65 in.)
New belt: 9.0-11.0 mm (0.35-0.43 in.)
Tension (measured with belt tension gauge)   Used belt: 390-540 N (40-55 kgf, 88-121 lbs)
New belt: 740-880 N (75-90 kgf, 165-198 lbs)

Suspension

Item Measurement Qualification Standard or New Service Limit
Wheel alignment Camber Front 0°00'+45°
Rear -0°45'+45'
Caster Front 1°33'+
Total Toe Front 0+3 mm (0+0.12 in.)
Rear Adjust: IN 2+2-1 mm (0.08+0.08-0.04 in.)
Inspect: IN 2+3 mm (0.08+0.12 in.)
Front wheel turning angle Inside wheel 38°00'±2°
Outside wheel 30°00' (Reference)
Aluminium wheel Runout Axial 0-0.7 mm (0-0.03 in.) 2.0 mm (0.08 in.)
Radial 0-0.7 mm (0-0.03 in.) 1.5 mm (0.06 in.)
Steel wheel Runout Axial 0-1.0 mm (0-0.04 in.) 2.0 mm (0.08 in.)
Radial 0-1.0 mm (0-0.04 in.) 1.5 mm (0.06 in.)
Wheel bearings End play Front 0-0.05 mm (0-0.002 in.)
Rear 0-0.05 mm (0-0.002 in.)