|Component Location Index||20-2|
|Door Panel Removal/Installation||20-4|
|Door Outer Handle Replacement||20-5|
|Door Latch Replacement||20-7|
|Door Glass and Regulator Replacement||20-9|
|Door Sash Trim Replacement||20-11|
|Door Glass Outer Weatherstrip Replacement||20-11|
|Door Weatherstrip Replacement||20-12|
|Door Upper Seal Replacement||20-12|
|Door Side Sill Seal Replacement||20-13|
|Door Channel Tape Replacement Process||20-14|
|Door Outer Channel Tape Replacement||20-15|
|Power Mirror Replacement||20-16|
|Component Location Index||20-17|
|Rear Window Replacement||20-24|
|Quarter Glass Replacement||20-29|
|Component Location Index||20-33|
|Trim Removal/Installation-Door Area||20-34|
|Trim Removal/Installation-Seat Side and Rear Shelf Area||20-35|
|Trim Removal/Installation-Trunk Area||20-36|
|* Front Seat Disassembly/Reassembly-Passenger's||20-40|
|Rear Seat-back Lock Cylinder Replacement||20-41|
|Rear Seat-back Cover Replacement||20-41|
|Rear Bumper Removal/Installation||20-43|
|Front Grille Replacement||20-44|
|Rear License Trim Replacement||20-44|
|* Trunk Lid Opener/Fuel Fill door Opener Cable Replacement||20-46|
|* Frame Repair Chart||20-48|
NOTE: Refer to the '01 CIVIC Shop Manual, P/N 62S5A00 on this CD, for the items not shown in this section.
Outline of 2-door Model Change
SUPPLEMENTAL RESTRAINT SYSTEM (SRS) (If body maintenance is required)
This model has an SRS which includes a driver's airbag in the steering wheel hub, a passenger's airbag in the dashboard above the glove box, seat belt tensioners in the front seat belt retractors, seat belt buckle tensioners in the front seat belt buckles and side airbags in the front seat-backs. Information necessary to safely service the SRS is included in the '01 Civic Shop Manual, P/N 62S5A00 on this CD. Items marked with an asterisk (*) on the contents page include or are located near SRS components. Servicing, disassembling or replacing these items will require special precautions and tools and should be done only by an authorised Honda dealer.
- To avoid rendering the SRS inoperative, which could lead to personal injury or death in the event of a severe frontal collision, all SRS service work must be performed by an authorised Honda dealer.
- Improper service procedures, including incorrect removal and installation of the SRS, could lead to personal injury caused by unintentional deployment of the airbags and/or side airbags.
- Do not bump the SRS unit. Otherwise, the system may fail in a collision, or airbags may deploy when the ignition switch is ON (II).
- SRS electrical wiring connectors are identified by yellow colour coding. Related components are located in the steering column, front console, dashboard, dashboard lower panel, in the dashboard above the glove box, in the front seats and around the floor. Do not use electrical test equipment on these circuits.