Doors

Door Outer handle Replacement (cont'd)

20-7

Door Latch Replacement


  1. Install the handle in the reverse order of removal and note these items:
  • Make sure the door locks and opens properly.
  • Make sure each rod is connected securely.
  • Make sure the door locks and opens properly.
  • When installing the lock cylinder, leave the outer door handle bolts loose so the inner protector does not interfere with the lock cylinder, then tighten the handle bolts.
  • Install the lock cylinder retaining clip on the handle, then install the lock cylinder. Be sure the clip is fully seated in the slot on the lock cylinder.

NOTE: Put on gloves to protect your hands.

  1. Raise the glass fully.
  2. Remove these items:
  • Door panel (see page 20-4)
  • Plastic cover, as necessary
  1. Disconnect the cylinder rod from the lock cylinder (see step 3 on page 20-5) and disconnect the outer handle rod from the outer handle (see step 7 on page 20-6).
  2. For some models: Remove the screw and release the clip (A) and hook (B) while pulling the cable protector (C) forward, then remove it from the latch (D) and door.

Fastener Location

: Screw, 1