Wheel Sensor Replacement - Without VSA

1.Release the holding of clamps (A), then disconnect the wheel sensor connector (B).


2.Remove the clips, the bolt, the O-ring (C) and the wheel sensor (D).

3.Install the wheel sensor in the reverse order of removal, and note these items:

  • Use a new O-ring on reassembly.
  • Install the sensor carefully to avoid twisting the wires.
  • If the wheel sensor comes in contact with the hub bearing, it is faulty.

4.Start the engine, and check that the ABS indicator goes off.

5.Test-drive the vehicle, and check that the ABS indicator does not come on.