OPDS Unit ReplacementNOTE: Review the seat replacement procedure before doing repairs or service.
|1.||Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.|
|2.||Disconnect the passenger's side airbag harness 2P connector.|
|3.||Remove the passenger's seat assembly and seat-back cover.|
|4.||Disconnect the OPDS unit 18P connector (D) and sensor connectors (B) from the OPDS unit (A).|
|5.||Remove the two nuts (C) and the OPDS unit.|
|1.||Place the new OPDS unit (A) on the seat-back frame. Tighten the two nuts (B), and connect the OPDS unit harness 18P connector (D) and sensor connectors (C) to the OPDS unit.|
|2.||Install the seat-back cover in the reverse order of removal. |
|3.||Install the seat assembly, then connect the side airbag harness 2P connector.|
|4.||Reconnect the negative cable to the battery.|
|5.||Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.|
|6.||Initialize the OPDS unit.|
|7.||After installing the OPDS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about |
6 seconds and then go off.