Side Impact Sensor (First) Replacement
NOTE: Review the seat replacement procedure
before doing repairs or service.
|1.||Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.|
|6.||Disconnect the floor wire harness 4P connector from the side impact sensor (first).|
|7.||Using a Torx T30 bit, remove the Torx bolt (A), then remove the side impact sensor (first) (B).|
|1.||Install the new side impact sensor (first) with the Torx bolt (A), then connect the floor wire harness |
4P connector (B) to the side impact sensor (first).
|2.||Reconnect the negative cable to the battery.|
|3.||After installing the side impact sensor (first) confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.|
|4.||Reinstall all removed parts.|