Front Door Outer Handle Replacement - With Super Locking
With Super Locking
NOTE: Put on gloves to protect your hands.
|3.||Disconnect the power door lock actuator connector (A).|
|4.||Remove the plug caps (B), then remove the plastic cover (C), as needed.|
|5.||Detach the rod fastener (A).|
|6.||Remove the maintenance cap (A). With a clip remover, disconnect the outer handle rod (B).|
|7.||Remove the bolt, then remove the spacer (A).|
|8.||Remove the bolt securing the outer handle protector (A), then remove the protector by releasing the hook (B).|
|9.||While pulling the outer handle (A), remove the handle from the holes in the door panel. Take care not to scratch the door.|
|10.||Remove the rod fastener (A) from the outer handle (B), then replace it with new one.|
|11.||Install the handle in the reverse order of removal, and note these items:|
- Make sure the cylinder cable and each rod is connected securely.
- Make sure the door key cylinder/door locks operate properly.
- Make sure the door handle works properly.
- When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.