Dashboard Subdisplay Visor Removal/Installation

NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the dashboard and related parts.
  • When removing components, use the handy remover set or equivalent.

1.Remove the driver's dashboard lower cover.

2.Tilt the steering column down, and telescope it out.

3.Remove the screw.

 

4.Pull the back of the switch panel (A) by hand from the driver's lower cover opening to release the clips (B) and hook (C) on the outside.

 

5.Pry up on the inside edge of the subdisplay visor (D) with a trim tool to detach the clip (E), and release the pin (F).

6.Detach the clips along the upper edge of the subdisplay visor (A). Gently pull out the visor to release the hooks (B).

 

7.Disconnect the illumination control switch connector (A). If equipped, disconnect the headlight adjuster switch connector (B) and VSA off switch connector (C).

 

8.If necessary, remove the screws, then remove the illumination control switch (A) and switch panel (B) from the subdisplay visor (C).

 

9.Install the subdisplay visor in the reverse order of removal, and note these items:

  • Make sure the connector is plugged in properly.
  • Check for damaged or stress-whitened clips, and if necessary, replace them with new ones.
  • Push the clips into place securely.