Door Glass Adjustment
NOTE: Check the weatherstrip and glass run channel for damage or deterioration, and replace them if necessary.
|1.||Place the vehicle on a firm, level surface.|
|3.||Carefully move the glass (A) until you can see the glass mounting bolts (B), then loosen them.|
|4.||Push the glass against the channel (C), then tighten the glass mounting bolts.|
|5.||Check that the glass moves smoothly.|
|6.||Raise the glass fully, and check for gaps. Also make sure that the glass (A) contacts the glass run channel (B) evenly.|
|7.||Check for water leaks. Run water over the roof and on the sealing area as shown, and note these items:|
- Use a 12 mm (0.47 in.) diameter hose (A).
- Adjust the rate of water flow as shown (B).
- Do not use a nozzle.
- Hold the hose about 300 mm (12 in.) away from the door (C).