DTC Troubleshooting: 21-11, 22-11, 23-11, 24-11
|DTC 21-11:||Right-front Magnetic Encoder Malfunction (Pulse Missing)|
|DTC 23-11:||Right-rear Magnetic Encoder Malfunction (Pulse Missing)|
|1.||Turn the ignition switch ON (II).|
|2.||Clear the DTC with the HDS.|
|3.||Test-drive the vehicle. Drive the vehicle at 20 km/h (13 mph) or more, and go a distance of 100 m (328 ft) or more.|
|4.||Check for DTCs with the HDS.|
Is DTC 21-11, 22-11, 23-11, and/or 24-11 indicated?
YES - Go to 5.
NO - Intermittent failure, the system is OK at this time. Check for loose terminals between the wheel sensor 2P connector and the ABS modulator-control unit 25P connector. Refer to intermittent failures troubleshooting.n
|5.||Turn the ignition switch OFF.|
|6.||Inspect the appropriate magnetic encoder for debris of cracks.|
Is the magnetic encoder surface OK?
YES - Replace the wheel bearing or the hub bearing unit:n
NO - Clean off dust or dirt from the appropriate magnetic encoder surface on the wheel bearing or the hub bearing unit, then go to step 1 and recheck.n