DTC Troubleshooting: 21-8x
|DTC 21-8x (21-80 to 21-89, 21-8A to 21-8F):||Short to Power in Left Side Seat Belt Tensioner|
Special Tools Required
SRS inflator simulator ( 07SAZ-TB4011A)
SRS simulator lead K ( 070AZ-SNA0200)
|2.||Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.|
Does the SRS indicator stay on, and is DTC 21-8x indicated?
YES - Go to 3.
NO - Intermittent failure, system is OK at this time.Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the DTC Troubleshooting Index.
|3.||Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes.|
|4.||Disconnect the floor wire harness 4P connector (A) from the left side seat belt tensioner.|
|5.||Connect the SRS inflator simulator (2 W connectors) and simulator lead K to the floor wire harness.|
|6.||Reconnect the negative cable to the battery.|
|9.||Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes.|
|12.||Disconnect the simulator lead from the floor wire harness.|
|13.||Reconnect the negative cable to the battery.|
|14.||Turn the ignition switch ON (II).|
|15.||Check for voltage between the No. 1 terminal of SRS unit connector B (28P) and body ground, and between the No. 2 terminal and body ground. There should be 0.5 V or less.|
Is the voltage as specified?
YES - Faulty SRS unit or poor connection at SRS unit connector B (28P) and the SRS unit. Check the connection; if the connection is OK, replace the SRS unit.n
NO - Short to power in the floor wire harness; replace the floor wire harness.n