DTC Troubleshooting: 26-8x

DTC 26-8x (26-80 to 26-89, 26-8A to 26-8F):Short to Power in Right Side Seat Belt Outer Lap Tensioner

Special Tools Required
SRS inflator simulator (  07SAZ-TB4011A)
 

SRS simulator lead M (  070AZ-SNA0400)
 


1.Erase the DTC memory.

2.Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on, and is DTC 26-81 indicated?


YES - Go to 3.


NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the DTC Troubleshooting Index for troubleshooting details.


3.Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes.

4.Disconnect the floor wire harness 2P connector (A) from the right side seat belt outer lap tensioner.

 

5.Connect the SRS inflator simulator (2 W connector) and simulator lead M to the floor wire harness.

6.Reconnect the negative cable to the battery.

7.Erase the DTC memory.

8.Read the DTC.

Is DTC 26-8x indicated?


YES - Go to 9.


NO - Short to power in the right side seat belt outer lap tensioner; replace the right side seat belt.n


9.Turn the ignition switch OFF. Disconnect the negative cable from the battery and wait for 3 minutes.

10.Disconnect the both seat belt tensioner 4P connectors.

11.Disconnect SRS unit connector B (28P) from the SRS unit.

12.Disconnect the SRS inflator simulator from the SRS simulator lead.

13.Reconnect the negative cable to the battery.

14.Turn the ignition switch ON (II).

15.Check for voltage between each terminal of the SRS simulator lead and body ground. There should be 0.5 V or less.

 

Is the voltage as specified?


YES - Faulty SRS unit; replace the SRS unit.n


NO - Short to power in the floor wire harness; replace the floor wire harness.n