DTC Troubleshooting: 34-1x
|DTC 34-1x (34-10 to 34-19, 34-1A to 34-1F):||Open or Increased Resistance in Right Side Curtain Airbag Inflator|
Special Tools Required
SRS inflator simulator ( 07SAZ-TB4011A)
|1.||Erase the DTC memory.|
|2.||Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.|
Does the SRS indicator stay on, and is DTC 34-1x indicated?
YES - Go to 3.
NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the DTC Troubleshooting Index.
|3.||Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes.|
|4.||Disconnect the floor wire harness 2P connector (A) from the right side curtain airbag connector (B).|
|5.||Connect the SRS inflator simulator (2 W connector) and simulator lead M to the floor wire harness.|
|6.||Reconnect the negative cable to the battery.|
|7.||Erase the DTC memory.|
|8.||Read the DTC.|
Is DTC 34-1x indicated?
YES - Go to 9.
NO - Open or increased resistance in the right side curtain airbag inflator, replace the right side curtain airbag.n
|9.||Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes.|
|10.||Disconnect SRS unit connector B (28P) from the SRS unit. Do not disconnect the simulator lead from the floor wire harness.|
|11.||Disconnect the SRS inflator simulator from the SRS simulator lead.|
|12.||Check resistance between the terminals of the SRS simulator lead. There should be 1.0 W or less.|
Is the resistance as specified?
YES - Faulty SRS unit or poor connection at SRS unit connector B (28P) and the SRS unit. Check the connection; if the connection is OK, replace the SRS unit .n
NO - Open or increased resistance in the floor wire harness; replace the floor wire harness.n