EPS Motor Removal and Installation
NOTE: Do not allow dust, dirt, or other foreign materials to enter the steering gearbox.
|2.||Disconnect the torque sensor 3P connector (A) from the steering gearbox, then remove the harness clamp bolts and ground terminal (B).|
|3.||Remove the motor (A) from the steering gearbox, then remove the O-ring (B) and discard it.|
|1.||Clean the mating surface of the motor (A) and steering gearbox.|
|2.||Apply a thin coat of silicone grease to the new O-ring (B), and carefully fit it on the motor.|
|3.||Apply silicone grease into the motor shaft (C).|
|4.||Install the motor on the steering gearbox by engaging the motor shaft and worm shaft (D).|
|5.||Before tightening the bolts, turn the motor two or three times right and left about 45 degrees. Make sure the motor is evenly seated on the steering gearbox, and that the O-ring is not pinched between the mating surfaces.|
|6.||Connect the torque sensor 3P connector (A) to the steering gearbox, then install the harness clamp bolts and ground terminal (B).|
|7.||Finish the installation, and note these items:|
- Make sure the torque sensor 3P connector is properly connected.
- Make sure the motor and EPS wires are not caught or pinshed by any parts.