DTC Troubleshooting: 12-1x, 12-4x

DTC 12-1x (12-10 to 12-19, 12-1A to 12-1F):Open or Increased Resistance in Front Passenger's Airbag First Inflator (LHD type)
  
  

Special Tools Required
SRS inflator simulator (  07SAZ-TB4011A)
 

SRS simulator lead J (  070AZ-SNA0100)
 


1.Erase the DTC memory.

2.Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on, and is DTC 12-1x, or 12-4x indicated?


YES - Go to 3.


NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the DTC Troubleshooting Index.


3.Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes.

4.Disconnect the front passenger's airbag 4P connector (A) from dashboard wire harness.

 

5.Connect the SRS inflator simulator (2 W connectors) and simulator lead J to the dashboard wire harness.

6.Reconnect the negative cable to the battery.

7.Erase the DTC memory.

8.Read the DTC.

Is DTC 12-1x or 12-4x indicated?


YES - Go to 9.


NO - Open or increased resistance in the front passenger's airbag first or second inflator; replace the front passenger's airbag.n


9.Turn the ignition switch OFF. Disconnect the negative cable from the battery, and wait for 3 minutes.

10.Disconnect SRS unit connector A (28P) from the SRS unit. Do not disconnect the simulator lead from the dashboard wire harness 4P connector.

11.Disconnect the SRS inflator simulator from the SRS simulator lead.

12.Check resistance between the terminals of both SRS simulator leads. There should be 1 W or less.

 


Is the resistance as specified?


YES - Faulty SRS unit or poor connection at SRS unit connector A (28P) and the SRS unit. Check the connection between the connector and the SRS unit. If the connection is OK, replace the SRS unit.n


NO - Open or increased resistance in the dashboard wire harness; replace the dashboard wire harness.n