Crankshaft Pulley Removal and Installation

Special Tools Required
Handle (  07JAB-001020B)
 

Crankshaft pulley holder (  070AB-RJA0100)
 
Socket wrench, 19 mm (  07JAA-001020A)
 


Removal


1.Remove the right front wheel.

2.Remove the drive belt.

3.Hold the pulley with the handle (A) and holder (B).

 

4.Remove the bolt with a 19 mm socket (C) and breaker bar, then remove the crankshaft pulley.

Installation


1.Clean the crankshaft pulley (A), crankshaft (B), bolt (C), and washer (D). Lubricate with new engine oil as shown.

¡: Clean  
l: Lubricate with new engine oil 

 

2.Install the crankshaft pulley, and hold the pulley with the handle (A) and holder attachment (B).

 

3.Tighten the bolt to 69 N·m (7.0 kgf·m, 51 lbf·ft) with a torque wrench and 19 mm socket (C). Do not use an impact wrench.

4.Tighten the pulley bolt an additional 90 °.

5.Install the drive belt.

6.Install the right front wheel.