Throttle Body Removal/Installation

Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II). If you do, you will seriously injure your fingers if the throttle valve is activated.

1.Remove the cowl cover and under-cowl panel.

2.Remove the air cleaner.

3.Disconnect the throttle body connector (A) and the EVAP purge control solenoid valve connector (B).


4.Disconnect and plug the water bypass hoses (C).

5.Remove the throttle body (D).

6.Install the parts in the reverse order of removal with a new gasket (E).