M/T Change Lever Assembly Disassembly/Reassembly

Exploded View


Special Tools Required
Attachment, 24 x 26 mm (  07746-0010700)

Driver (  07749-0010000)

1.Remove the breather cap (A), detent bolt (B), washer (C), spring (D), and steel ball (E).
Remove the detent bolt (F) and the lockout solenoid (G).


2.Remove the special bolt (A) and spring washer (B).


3.Remove the shift lever (C) and shift arm (D) from the shift arm cover (E).

4.Remove the oil seal (F).

NOTE: When installing, turn the alloy surface of the thrust washer to the shift arm cover side.

5.Remove the spring pin (A) from the select lever (B).

NOTE: Install the spring pin into the interlock with the groove of the spring pin at the angle shown.


6.Remove the select lever from the shift arm cover (C), then remove the shift piece (D) and the interlock (E).

7.Remove the oil seal (F).

8.Install in the reverse order of removal.

9.Remove the dirt and oil from the sealing surface. Apply liquid gasket (P/N 08718-0002) to the sealing surface.

NOTE: Do not install components if too much time has passed after applying the liquid gasket (for P/N 08718-0002, no more than 4 minutes, for all others, no more than 5 minutes). Instead, remove the old residue and reapply the liquid gasket.

10.Install the oil seal (A) using the special tools.