A/T Housing and Shaft Assembly Removal
Special Tools Required
Housing puller ( 07HAC-PK40102)
|1.||Remove the shift solenoid valve cover (A), dowel pins (B), gasket (C), and harness clamp bracket (D).|
|2.||Disconnect the connectors from the shift solenoid valves, and remove the solenoid harness connector (E).|
|3.||Remove the transmission housing mounting bolts (F) (19).|
|4.||Align the spring pin (A) on the selector control shaft (B) with the transmission housing groove (C) by turning the selector control shaft with the detent plate.|
NOTE: Do not squeeze the end of the selector control shaft tips together when turing the control shaft.
|5.||Install the special tool over the mainshaft, then remove the transmission housing.|
NOTE: If the top arm of your housing puller is too short, replace it with housing puller arm, 205 mm 07SAC-P0Z0101.
|6.||Remove the countershaft reverse gear and needle bearing.|
|7.||Remove the lock bolt securing the shift fork, then remove the shift fork with the reverse selector together.|
|8.||Remove the mainshaft subassembly (A), countershaft subassembly (B), and secondary shaft subassembly (C) together.|
If the reverse selector hub is removed by hand, remove the 4th-5th gear and needle bearings, and remove the mainshaft subassembly, then the countershaft subassembly and secondary shaft subassembly together.
|9.||Remove the differential assembly.|