A/T Countershaft Reverse Selector Hub Installation
Special Tools Required
Driver, 40 mm I.D. ( 07746-0030100)
|1.||Install the 1st gear, 2nd gear, 3rd gear, 33.2 x 40 x 26 mm collar, 29 mm cotters, and 33 x 45 x 7.8 mm collar on the countershaft, and secure them with the snap ring.|
|2.||Install the needle bearings and 4th-5th gear.|
|3.||Slide the reverse selector hub (A) over the countershaft (B), then press it in place with the special tool and a press.|
NOTE: Some reverse selector hubs are not press-fitted, and can be installed without using the special tool a press.