A/T 2nd, 3rd, 4th, and 5th Clutch Disassembly

Special Tools Required
Clutch spring compressor set (  07LAE-PX40000)
 

Clutch spring compressor attachment (  07LAE-PX40100)
 
Clutch spring compressor attachment (  07HAE-PL50101)
 
Clutch spring compressor bolt assembly (  07GAE-PG40200)
 
Snap ring pliers (  07LGC-0010100)
 


1.Remove the snap ring with a screwdriver.

 

2.Remove the clutch end-plate (A), clutch discs (B) (4), clutch flat-plates (C) (4), and waved spring (D) from the 2nd clutch drum (E).

 

3.Remove the clutch end-plate (A), clutch discs (B) (4), clutch flat-plates (C) (4), and waved spring (D) from the 4th clutch drum (E).

 

4.Remove the clutch end-plate (A), clutch discs (B) (4), clutch waved-plates (C) (4), and waved spring (D) from the 3rd clutch drum (E).

 

5.Remove the clutch end-plate (A), clutch discs (B) (4), clutch waved-plates (C) (4), and waved spring (D) from the 5th clutch drum (E).

 

6.Install the special tools.

 

7.Be sure the special tool (A) is adjusted to have full contact with the return spring retainer (B).

 

8.If either end of the special tool is set over an area of the spring retainer that is unsupported by the return spring, the retainer may be damaged.

 

9.Compress the return spring until the snap ring can be removed.

 

10.Remove the snap ring with the snap ring pliers.

 

11.Remove the special tools.

12.Remove the snap ring (A), spring retainer (B), and return spring (C).

 

13.Wrap a shop rag around the clutch drum, and apply air pressure to the fluid passage to remove the piston. Place a finger tip on the other passage while applying air pressure.

 

14.Remove the clutch piston (A), and remove the outer O-ring (B) and inner O-ring (C) from the piston.