APP Sensor Signal InspectionNOTE:
- This procedure checks the APP sensor in its fully closed position. In any other position, the APP sensor stores DTCs which are covered in other troubleshooting procedure.
- Check for Temporary DTCs or DTCs with the HDS before doing this procedure. If any DTCs are indicated, troubleshoot them first, then do this procedure.
- Press the accelerator pedal several times, to check its operation. If it does not operate smoothly, check the pedal. If you find a problem, replace the accelerator pedal module.
|1.||Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.|
|2.||Turn the ignition switch ON (II).|
|3.||Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.|
|4.||Make sure the accelerator pedal is not pressed, then check the APP SENSOR in the DATA LIST with the HDS.|