M/T Clutch Housing Countershaft Bearing Replacement

Special Tools Required
Adjustable bearing puller, 20-40 mm (  07JAC-PH80100)
 

Oil seal driver (  07JAD-PL90100)
 


1.Remove the bearing set plate (A) from the clutch housing (B).

 

2.Remove the needle bearing (A) using the special tool and a commercially available 3/8''-16 UNF slide hammer (B), then remove the oil guide plate C.

 

3.Position the oil guide plate C and new needle bearing (A) in the bore of the clutch housing (B).

 

4.Install the needle bearing using the special tool.

5.Install the bearing set plate (A) with bolts (B).