A/T Housing Bearing Removal
Special Tools Required
Driver attachment, 78 x 90 mm ( 07GAD-SD40101)
Driver attachment, 42 x 47 mm ( 07746-0010300)
Snap ring pliers ( 07LGC-0010100)
|1.||Remove the idler gear shaft when removing the mainshaft bearing and idler gear shaft bearing.|
NOTE: If you are only removing the countershaft bearing, idler gear shaft removal is not needed.
|2.||To remove the mainshaft bearing (A) and countershaft bearing (B) from the transmission housing, expand each snap ring with the snap ring pliers, then push the bearing out.|
NOTE: Do not remove the snap ring unless it's necessary to clean the grooves in the housing.
|3.||Expand the snap ring of the idler gear shaft bearing with the snap ring pliers, then push the bearing out.|