A/T Differential Carrier Bearing Outer Race Replacement
Special Tools Required
Handle driver ( 07749-0010000)
Driver attachment, 72 x 75 mm ( 07746-0010600)
- Replace the bearing with a new one whenever the outer race is replaced. The bearing and bearing outer race should be replaced as a set.
- Adjust the preload after replacing the bearing and the outer race.
|1.||Remove the bearing outer race (A), 76.2 mm thrust washer (B), and 76 mm thrust shim (C) from the transmission housing (D) by heating the housing to about 100 °C (212 °F) with a heat gun (E). Do not heat the housing more than 100 °C (212 °F).|
|2.||Remove the bearing outer race and 80 mm thrust washer from the torque converter housing by hand.|
|3.||Install the 76 mm thrust shim (A), 76.2 mm thrust washer (B), and outer race (C) in the transmission housing (D).|
|4.||Drive the outer race securely in the housing so there is not clearance between the outer race, thrust washer, thrust shim, and housing with the special tools.|
|5.||Install the 80 mm thrust washer (A) and outer race (B) in the torque converter housing (C).|
|6.||Drive the outer race securely in the housing so there is not clearance between the outer race, thrust washer, and housing with the special tools.|