- Drive the new oil seal in from the transmission side using the special tools.
- Drive the new ball bearing (A) in from the transmission side using the special tools.
Special Tools Required
- Oil seal driver, 07JAD-PL90100
- Adjustable bearing puller, 20 - 40 mm, 07JAC-PH80100
- Slide hammer, 07741-0010201
- Bearing remover shaft, 07JAC-PH80200
- Remove the bearing set plate (A) from the clutch housing (B).
- Remove the needle bearing (A) using the special tools, then remove the oil guide plate C (B).