Summary of Contents for Honda Civic 1984 Service Manual - Page 11

  • Honda Civic 1984 Service Manual - Page 11

    Preparation of Work i- Electrlcal (contd) - All plastic plugs have lockino tabs that must be re- leased oarore disconnecting, and must be aligned when reconnecting l wnen disconnecting a coupler, pull it off lrom the mating coupler by holding on both couplers. » Never try to disconnect couplers by pulling on their wires. ~ Before connecting couplers, check to see that the terminals are in place and are not bent or distorted. - Insert couplers fully until they will no longer gol ‘ Some couplers have locking tabs that must be aligned and engaged securely. Dont use wire harnesses with a loose WIre or coupler. $30) Place the plastic cover over the mating coupler alter reconnecting. Also check that the end is not inverted, .Q _>< - Before connecting, check each connector cover ror breaka 2. Also make sure that the female connector is tigh and not pried open from the prevrous use. X ~ Insert male connectors into the female connectors lully until they will no longer on. s Be sun that plastic cover is placed over theconnection. ~ Don’t place the opening or each plastic cover facing up. ‘ Secure wires and wire harnesses to the frame with their respective wire bands at the designated locations. Tighten the bands so that only the insulated surfaces contact the wires or wire harnesses. O X A loose wire harness or cable can be a hazard to safety. Alter clamping, check each wire for securltv in its clamp. KO x MM ~ Do not squeeze wires against the weld or nugget oi its clamp when a weld-on clamp is used. 0 x kfl 1-12