Summary of Contents for Honda Civic 1987 Service Manual - Page 9

  • Honda Civic 1987 Service Manual - Page 9

    —- Special Caution Items For This Car Preparation of Work Apply liquid gasket to the transmission, oil pump cover, right side cover and water outlet. Use HONDA PARTS NO 08740—99936 as a liquid gasket. - Check that the mating surfaces are clean and dry before applying liquid gasket. Degrease the mating surfaces if necessary. - Apply liquid gasket evenly, being careful to cover all the mating surface. - To prevent leakage of oil, apply liquid gasket to the inner threads of the bolt holes. ~ Do not allow liquid gasket to stand for more than 20 minutes before assembly. - Fill the case with clean engine oil or coolant 30 minutes after assembly. Fuel Line Servicing lFueHnjected Engine) - Relieve fuel pressure by loosening the service bolt provided on the top of the fuel filter before disconnecting a fuel hose or a fuel pipe. SERVICE BOLT - Be sure to replace washers, O-rings, and seal rubbers with new ones when servicing fuel line parts, - Always apply oil to the surfaces of Ovrings and seal rings before installation. Never use brake fluid. radiator fluid, vegetable oils or alcohol- based oils. SEAL RUBBER O-filNG CUSHION RING FUEL INJECTOR - When assembling the flare joint of the high- pressure fuel line, clean the joint and coat with new engine oil. ‘ When installing an injector, check the angle of the coupler, The center line of the coupler should align with the setting mark on the injector holdert EUEI. PIPE SETTING MARKS Inspection for fuel leakage (Fuel-Injected Engine) - After assembling fuel line parts, turn ON the ig- nition switch [do not operate the starter) so that the fuel pump is operated for approximately two seconds and the fuel is pressurized. Repeat this operation two or three times and check whether any fuel leakage has occurred in any of the vari- ous points in the fuel line Installation of an amateur radio for cars equipped with PGM—Fl and A.L,E. Care has been taken for the PGM»FI and ALB. con- trol units (computerl and its wiring to prevent erroneous operation from external interference, but erroneous operation of the computer may be caused by entry of extremely strong radio waves Attention must be paid to the following items ta prevent erroneous operation of the computer. - The antenna and the body of the radio must be at least 200 mm (19 int] away from the computer, (The computer installation posilion is under the right side seat) - Do not lead the antenna feeder and the coaxial cable over a long distance parallel to the wiring, and when crossing with the wiring is required. execute crossing at a right angle. - Do not install a radio with a large output (max. 10 W). 1-10