Summary of Contents for Honda Civic 1990 ED9 ED6 Service Manual - Page 9

  • Honda Civic 1990 ED9 ED6 Service Manual - Page 9

    3. When assembling the llare ioint ol the high- pressure luel llne, clean the ioint and coat With new engine oil. When Installing an injector, check the angle ol the connector. The eanter line or the connector should align with the setting mark on the inteotor holder. FUEL PIP E SETTING MARKS Inspection lor luel leakage After assembling luel line pansy turn ON the lg» nition switch (do not operate the starter) so that the fuel pump is operated lo: approximately two seconds and the fuel is pressurlxed. Repeat this overetion NM) or three time: and check whether any fuel leakage has occurred tn any 0 the Valle nus points In the fuel lines Installation ol an amateur radios Care has been taken (or the PGMaFl ECU (control unit] and its wiring to prevent erroneous operation from external interlerence, but erroneous operation of the control unit may be caused by extremely strong radio waves. Attention must be paid to the followmg items to prevent enoueou5 operation of the control unit. - Tlte antenna and the body ol Ihe radio must be at least 200 mm (7.9 in ) away from the computer, The control unit location- ~ PGM’FI ECU I Passengers side front fluor panel ~ ALB control unit: Rear luggage area Right front of floor panel. A/T control. Drivers side from floor panel ~ Do nol lead the antenna feeder and the coaxial cable over a long distance parallel to the car’s wiring. When crossing with the wiring ts required. execute crossing at a right angle. Do not install a radio with a large output (max. 10 W). Apply liqulo gasket to the transmission oil pump covet] right side cover and water outlet. Use Hana. genuine liquid gasket, Part NO ovuo —99986. r Check that the mating sullaces are clean and dry before applying lluuld gasket. Decrease the mating surlaces if necessary. - Apply liquid gasket evenlyy being carelul to cover all the mating surtace. - To prevent leakage of oil, apply liguid gasket to the inner threads 0 the bolt holes. . Do not Install the parts If 20 mlnules or more have elapsed slnce applylng Ilquid gasket, In that case, reapply liquid gasket after removing the oldresldue. ~ After assembly, w at least 30 minutes before filling the appropriate liquid (engine oil, coolant and other similar fluid). 1-10