Summary of Contents for Honda Civic 1990 VTEC Service Manual - Page 22

  • Honda Civic 1990 VTEC Service Manual - Page 22

    Preparation of Work —E|ectrica| (cont’d) I For the connector which uses insulation grease. clean the connector then apply grease it the grease is insufficient or contaminated. 0 Insert the connector tightly and make sure it is securely locked. I Check all the wire harnesses are connected. I There are two types of locking tab: one that you have to push and the other you should not touch when connecting the connector. Check the shape of the locking tab before connecting. - The locking tab having a taper end should not be touched when connecting. i O The locking tab with an angle and should be pushed when connecting. i] 0 Insert connectors lullv until they will no longer go. 0 The connectors must be aligned and engaged securely. 0 Do not use wire harnesses with a loose wire or connector. N 0 GOOD 0 Before connecting, check each connector cover tor damage. Also make sure that the female connector is tight and not loosened lrom the previous use. 0 NO GOOD X 0 Insert male connectors into the lemale connectors lullv until they will no longer go. 0 Be sure that plastic cover is placed over the connection. 0 Position the wires so that the open end at the cover faces down. No GOOD 0 Secure wires and wire harness to the heme wlth their respective wire bands at the designated locations. Position the wiring in the hands so that only the in- sulated surlaces contact the wires or harnesses. 0 Remove with care not to damage the lock. NO GOOD x SNAP-RING PLIER 1-16