Wheel Bearing End Play Inspection

1.Raise the vehicle, and make sure it is securely supported. Remove the wheels.

2.Install suitable flat washers (A) and wheel nuts, and tighten the nuts to the specified torque to hold the brake disc securely against the hub.



3.Set up the dial gauge against the hub cap or hub flange as shown, and measure the bearing end play by moving the brake disc inward and outward.

Bearing end play: 
 Front/rear: 0-0.05 mm (0-0.002 in.) 

4.If the bearing end play is more than the standard, replace the wheel bearing.