Rear Door Latch Replacement

NOTE: Put on gloves to protect your hands.

1.Remove these items:


2.Raise the glass fully.

3.Remove the access cap, than disconnect the outer handle rod.

4.Disconnect the lock rod (A) from the lock crank (B), and release the inner handle rod (C) and lock rod from the rod holder (D).

 

5.Without Super Locking: Remove the latch (A). Take care not to bend the inner handle rod (B), lock rod (C), and outer handle rod (D). The Honda Lock make is shown (the Mitsui make is similar).

-1 Disconnect the connector (E).
-2 Remove the screws.
-3 Remove the latch from the hole in the door.

 

6.With Super Locking: Remove the latch (A). Take care not to bend the inner handle rod (B), lock rod (C), and outer handle rod (D).

-1 Disconnect the connector (E), and detach it.
-2 Remove the bolts (F), then release the wire harness (G) from the door.
-3 Remove the screws (H)
-4 Remove the latch from the hole in the door.

 

7.If necessary, remove the lock crank (A) from the door.

 

8.Install the latch in the reverse order of removal, and note these items:

  • Make sure the connector is plugged in properly, and each rod is connected securely.
  • Make sure the door locks and opens properly.