Combination Light Switch Test/Replacement


1.Remove the steering column covers.

2.Disconnect the 16P connector (A) from the combination light switch (B).

LHD type and KE model: 

RHD type: 

3.Remove the two screws, then slide out the combination light switch.

4.Inspect the connector terminals to be sure they are all making good contact.

  • If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
  • If the terminals look OK, check for continuity between the terminals in each switch position according to the tables.
    • If the continuity is not specified, replace the switch.